USER MANUAL
PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
61
provider’s network default gateway).
Click
WAN Settings
Tab to configure parameters necessary for GSM/UMTS connection. All
parameters necessary for connection configuration should be required from mobile operator.
Check the status of GSM/UMTS connection (
WAN Settings
Tab). If disconnected please click
Connect
button.
Click
VPN Settings
>
GRE
to configure GRE tunnel parameters:
-
Enable: yes
-
Local Tunnel Address: 10.10.10.1
-
Local Tunnel Netmask: 255.255.255.252 (Unchangeable, always 255.255.255.252)
-
Tunnel Source: 10.251.49.2 (select HOST from drop down menu if you want to use host
name as peer identifier)
-
Tunnel Destination: 10.251.49.3 (select HOST from drop down menu if you want to use host
name as peer identifier)
-
KeepAlive enable: no
-
Period:(none)
-
Retries:(none)
-
Press ADD to put GRE tunnel rule into GRE table.
-
Press
Save
to accept the changes.
Click
Routing
on
Settings
Tab to configure GRE Route. Parameters for this example are:
-
Destination Network: 192.168.2.0
-
Netmask: 255.255.255.0
-
Interface: gre_x
Optionally configure IP Filtering and TCP service port settings to block any unwanted incoming
traffic.
On the device connected on PRESTO Advanced router 1 setup default gateway 192.168.4.1
The PRESTO Advanced Router 2 configuration:
Click
Network
Tab, to open the
LAN NETWORK
screen. Use this screen to configure LAN TCP/IP
settings. Configure IP address and Netmask.
-
IP Address: 192.168.2.1
-
Subnet Mask: 255.255.255.0
-
Press
Save
to accept the changes.
Use SIM card with a static IP address, obtained from Mobile Operator. (Note the default gateway
may show, or change to, an address such as 10.0.0.1; this is normal as it is the GSM/UMTS
provider’s network default gateway).
Click
WAN Settings
Tab to configure parameters necessary for GSM/UMTS connection. All
parameters necessary for connection configuration should be required from mobile operator.
Check the status of GSM/UMTS connection (
WAN Settings
Tab). If disconnected please click
Connect
button.
Click
VPN Settings
>
GRE
to configure GRE tunnel parameters:
-
Enable: yes
-
Local Tunnel Address: 10.10.10.2
-
Local Tunnel Netmask: 255.255.255.252 (Unchangeable, always 255.255.255.252)
-
Tunnel Source: 10.251.49.3 (select HOST from drop down menu if you want to use host
name as peer identifier)
-
Tunnel Destination: 10.251.49.2 (select HOST from drop down menu if you want to use host
name as peer identifier)
-
KeepAlive enable: no
-
Period:(none)
