6.
INSTALLATION PROCEDURE
DCRCAM1
(PLUG AND PLAY OBD II CABLE)
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
Mount the camera to the windshield or dashboard by firmly pressing the
camera in place for 30 seconds.
(Ensure the camera lens is facing forward with an unobstructed view of the road)
To adjust the camera angle use the provided Allen key and adjust the mount-
ing bracket until you get the desired angle and then tighten the mount in
place.
Once the camera’s angle is set, plug in the cameras power cable and
secure
the cable in place using the two phillips screws provided, route the power
wire up towards the headliner or front windshield seem and then route the
cable left and down the driver’s A-pillar into the drivers’ dashboard area near
the factory OBD II port and plug the DCRCAM1 connector into the OBD II port.
Secure the excess power cable extension into the headliner or under the
dash area with the mounting adhesive tabs included with the camera.
Ensure the plastic protective film is removed from front facing and interiror
facing lenses.
