10.
TROUBLESHOOTING
DCRCAM1 won’t power on:
Can’t access the DCRCAM1 account:
Display shows no SD Card:
• Plug and play installation - Check the vehicle OBD II port for 12 Volt + pow-
er on pin 16 and confirm ground in Pin 5 , the the port does not have power
refer to the vehicle manaul and check the DLC/Aux fuse and replace fuse if it
is blown.
All cameras require an account acceptance agreement and payment meth-
od, if you have not set up your account or did not receive a welcome email
from M2M in motion – Please locate the serial number noted on the Invoice,
product box, or base of the camera and web search
m2minmotion.com/get-
started or contact support at 727-732-2727
The DCRCAM1 is shipped with a specific class 256 MB sd card that needs to
be inserted into the camera, if the card is inserted but not showing-Power off
the camera by turning off the vehicle’s ignition or pressing the power reset
button located on the base of the camera and allow the camera to reboot.
• Hardwired installation - using the AHRHW Accessory cable, confirm the
connections-12 Volts+ on the Red wire and chassis ground on the Black wire-
and confirm the 3 AMP fuse is good.
