R3-NMW1F
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-8286 P. 2 / 10
CAUTION REGARDING RADIO FREQUENCY
■
FCC NOTICE
• This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
■
FCC CAUTION
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s au-
thority to operate the equipment.
■
NOTE
• This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accord-
ance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to cor-
rect the interference at his own expense.
• This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
■
FCC RF EXPOSURE INFORMATION
• This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guide-
lines. This equipment should be installed and operated
keeping the radiator at least 20 cm or more away from
person’s body.
FCC ID: 2AOTF-0000008 (with no power supply)
FCC ID: 2AOTF-0000009 (24 V DC)
FCC ID: 2AOTF-0000010 (100 – 240 V AC)
Contains FCC ID: 2AKGW-1TD3016A1
INSTALLATION
Use the Installation Base Model R3-BS, or Model R3-BSW
for free I/O address capability.
Before mounting the Network Interface Module onto the
Base, please do the following.
■
DATA ALLOCATION
Set the DIP switches (SW1, SW2) so as to assign the data
area size to each I/O module mounted on the base.
The data sent/received via Modbus is mapped according to
the setting.
See “COMPONENT IDENTIFICATION” and “MODBUS
I/O ASSIGNMENTS.”
■
MOUNTING TO THE BASE
I/O 1
I/O 2
I/O n
With Model R3-BS base, mount the I/O Modules from the
left end (I/O 1) to the right in order that the Network Mod-
ule assigns data areas from I/O 1.
Network Module(s) and Power Module are mounted basi-
cally at the right end though technically they could be
mounted in any position.
With Model R3-BSW base, there is no limitation in mount-
ing positions as I/O address can be assigned freely to each
module using rotary switches equipped on the base.