3
www.m-locks.com
Tantum
V02
EN
!
Caution!
•
The lock has been designed for use in a temperature range from +10˚C to +50˚C and a non-
condensing humidity range from 30% to 80%.
• It may only be cleaned with a moist cloth (do not use aggressive cleaning agents).
• The lock may only be installed by qualified fitters.
• The lock may not be lubricated.
• Never open the lock housing. If it is necessary to disassemble the hardware, only do so in
accordance with the technical instructions. If you fail to do so, the lock may no longer function
properly and you will forfeit your right to warranty.
2
CHARACTERISTICS
The motor lock can be mounted in all four mounting directions. The mounting dimensions are
standard. The lock is delivered with metric (M6) mounting screws.
The electronics feature a 6-digit main code (in some cases it may be that the lock requires a 7-digit
code) that can be changed by the user. With the main code user code(s) can be activated and deleted.
After entering a valid code, a double signal sounds and the motor will retract the lock bolt. You can
now open the door/bolt work. Closing the lock can either be done automatically by closing the door/
bolt work (Automatic Closing) or by pushing a random digit on the keypad (Push to Close). The default
closing mode is Push to Close. The main code can change the closing mode to Automatic closing. To
achieve “Automatic Closing” it is imperative that a door-/bolt work switch (NC=Normally Closed) is
connected to the lock.
If the door is not opened within 5 seconds, the lock will automatically lock again in case “Automatic
Closing” is active.
A signal will sound every 10 seconds as long as the lock is open in case “Push to Close” is active.
Three long tones will sound when during opening or closing the lock bolt is blocked. Entering the code
again will close, respectively open the lock again. Remove the obstruction and retry.
