M/A-Com Orion, Installation Manual

Page: 12 / 80

12
STEP 2 - LOCATE TOOLS REQUIRED
The equipment required for installing the Orion Mobile Radio is listed below:
•
Crimping tool for fuse holder
•
Electric drill for drilling mounting holes
•
Drills and circle cutters as follows:
No. 31 (1/8”) drill
No. 27 (9/64”) drill
5/8” drill or circle cutter
3/4” circle cutter, hole saw or socket punch
•
Phillips and flat-blade screwdrivers
•
POZIDRIV
®
driver
•
No. 20 TORX
®
driver
CAUTION
Be careful to avoid damaging vital part (fuel tank,
transmission housing, etc.) of the vehicle when drilling
mounting holes. Always check to see how far the mounting
screws will extend below the mounting surface before
installing.
If pilot holes must be drilled, remove all metal shavings from
drilling holes before installing screws.
Vehicles Powered By Liquefied (Lp) Gas
Radio installation in vehicles powered by liquefied petroleum gas, where
the LP gas container is located in the trunk or other sealed-off space
within the interior of the vehicle, must conform to the National Fire
Protection Association Standard NFPA 58. This requires that:
•
The space containing radio equipment be isolated by a seal from the
space containing the LP gas container and its fittings.
•
Outside filling connections be used for the LP gas container.
•
The LP gas container space be vented to the outside of the vehicle.