5
+
-
12-24 V DC
COM
NC
COM
NC
*
*
4
3
1
C A
B
CLASS 1 LASER PRODUCT
CAUTION! CLASS 3R LASER
RADIATION ACCESSIBLE
DURING INSTALLATION.
AVOID DIRECT EYE EXPOSURE!
CLASS 1 LASER PRODUCT
CAUTION! CLASS 3R LASER
RADIATION ACCESSIBLE
DURING INSTALLATION.
AVOID DIRECT EYE EXPOSURE!
PUSH BUTTONS
VISIBLE SPOTS AND CURTAIN ADJUSTMENT
POWER SUPPLY
TEST / MONITOR
R1(RELAY)
R2(OPTO)
GREEN
BROWN
YELLOW
WHITE
PINK
GREY
RED
BLUE
*
See output configuration (page 7)
Quickly press the push button twice to activate the visible spots, and then adjust the tilt angle (range: 0 to +5°
)
with the
screwdriver until the visible spots are at the correct position.
Recommended position for the visible spots:
Try to position the red spots as close to the door as possible. Just make sure the door is not detected!
If 2 m mounting height:
d
≥4cm If 3 m mounting height:
d
≥5cm
If 4 m mounting height:
d
≥6cm If 5 m mounting height:
d
≥7cm
ADJUSTMENTS & SETTINGS
Sword zone
WIRING
Quickly press twice
to activate or deactivate the visible laser spots
Press for 2 seconds
to launch a teach-in process
Press for 3 seconds
to confirm the setting after changing the DIP switch
Press for 5 seconds
to acknowledge the 6x flashing error message and confirm that you
want the sensor to be mounted higher than 4m. Note that the sensor
does not comply with DIN 18650-1 and EN 16005 above this height.
For compliance with EN 16005 and DIN 18650-1, the door controller test output must be connected and testing
the sensor.
Do not stare into the visible beams !
Pinch zone
