CARE AND CLEANING INSTRUCTIONS
+ Clean surface with nonabrasive liquid detergent and warm water.
Use cleaning products such as Soft Scrub Gel®, Comet Gel®,
Gel Gloss® or other similar products.
+ DO NOT USE ABRASIVE CLEANERS, "steel wool" or wire brushes on
surface. Caustic drain cleaners may cause surface damage. Open
flames (cigarettes, candles, etc.) may damage surface.
+ Surface damage-light scratches, dulled areas, and small cuts and
are restored by first scrubbing with automotive-type white body
cleaning compound, such as Meguire's #9 Swirl®Remover,
followed by an application of Gel Gloss®. See next page for
detailed Scratch Repair Instructions.
+ Remember to always use a cutting board or sink protector when
using knives or sharp objects in your sink.
+ Recommendation: When pouring boiling water or placing hot
pots or pans into the sink, run some cold water simultaneously.
WARNING: Some cleaning products are not suitable for use.
Read all labels carefully. DO NOT USE if they say “not suitable for use with ABS, acrylic or polystyrene”. Always
rinse cleansers thoroughly within five minutes of application.
Page 6
Connect hot and cold faucet supply, drain pipes,
garbage disposal and trap assembly. Depending
on the location of the sink drain holes, it may be
necessary to adjust the drain pipe fittings under
the sink.
NOTE:
It’s important to check that there are
no leaks. Turn on your water supply and check
all connections. If a leak is found, tighten joint
slightly, making sure not to over tighten. With
a stopper in place, fill each sink bowl. Check
for any leaks under sink and around drain
flange. Remove stopper and while the water is
draining, check your drain connections.
11.
11
Apply a high grade of color-matched silicone. Apply
the silicone around the sink, including the front
apron.
Warning:
Do not use plumber’s putty. It will cause
product failure and void warranty. Use a high
grade silicone for all necessary locations.
10.
10
