REPLACING YOUR OLD SINK:
Note: If replacing a sink in an existing counter top, the sink cutout in the counter top
must not exceed 327/16” or be more than 207/16” from the front edge. If the existing cutout
exceeds these dimensions then a new counter top is required. Measurements are based
on 24” deep base cabinet and 25” counter top.
IMPORTANT - Refer to the counter top manufacturer to determine the appropriate
cutting method for your counter top.
IMPORTANT - The clip system on this sink is designed to hold it in place while the
silicone dries. If the sink opening is too large the sink can be weighed down to hold it in place while the silicone
dries. Take care not to scratch the sink if using a weight.
INSTALLATION INSTRUCTIONS
Verify that your counter top is level. Measure the false
drawer openings on the kitchen cabinet to ensure the sink
apron will cover the entire opening.
Note: If false drawer fronts are larger than the width and/
or height of the apron, fill in any gaps.
Remove false drawer fronts from the cabinet where the
apron will be located.
1.
1
Page 2
IMPORTANT
• Read installation instructions carefully before starting project.
• Keep instructions for warranty information.
• Peel back protective film to verify color before installation.
• Do not use plumber’s putty. It will cause product failure and void warranty. Use a high
grade silicone caulk for all necessary locations.
TOOLS YOU WILL NEED:
Tape Measure
Carpenter’s Square
Straight Edge (3 Feet)
Jig Saw or Saber Saw (Fine Tooth Blade)
Masking Tape (3")
Two 3 1/2" Drains
Silicone Caulk
20-7/16 in.
32-7/16 in.
33-3/4 in.
5/8 in.
5/8 in.
Cut notch from
front of cabinet to
front of countertop
Front of Cabinet
Front of Countertop
Countertop Cutout
COMPLIANCE CERTIFICATIONS:
ANSI Z124.6 AND CAN/CSA-B45.5
