Lynx Rave 800, Owner'S Manual

Page: 156 / 190

OPERATOR’S GUIDE 31
ENGLISH
BREAK-IN PERIOD
Engine
CAUTION!
A break-in period of 10 to 15 operating hours-500 km –is required before running the
snowmobile at full throttle.
During break-in period, maximum throttle throttle should not exceed 3/4. However, brief full
acceleration and speed variations contribute to a good break-in. Continued wide open throttle
accelerations, prolonged cruising speeds and engine overheating are detrimental during the
break-in period.
To assure additional protection during the initial engine break-in, 500 ml recommended
injection oil should be added fuel for the first full filling of fuel tank.
Always remove and clean spark plugs after engine break-in.
Belt
A new drive belt requires a break-in period of 50 km. Avioid strong acceleration/decleration,
pulling a load or high speed cruising.
10-hour inspection
As with any precision piece of mechanical equipment, we suggest that after the first 10
hours of operation-500 km-or 30 days after the purchase, which ever comes first, your
snowmobile be checked by an authorized Lynx service shop.
This inspection will give you the opportunity to discuss the unanswered questions you may
have encountered during the first hours of operation.
NOTE! The 10 hour inspection is at the expence of the snowmobile owner.
PRE-OPERATION CHECK
• Activate the throttle control lever several times to check that it operates easily and
smoothly. It must return to idle position when released.
• Activate the brake control lever and make sure the brake fully applies before the brake
control lever touches the handlebar grip. It must fully return when released.
• Verify that skis and steering operate freely. Check corresponding action skis versus
handlebar.
• Verify track and idler wheels are unfrozen and free to turn.
• Check fuel and injection oil for levels. Replenish as necessary and see an Lynx authori-
zed service shop in case of any leaks.
• Verify that air filter(s) is free of snow, if so equipped.
• Check gear shift lever position.