18
CARE AND USE/INSTALLATION
CLEANING YOUR ICE MACHINE
Figure 27
Figure 26
Remove all of
the ice from
the ice bin
Figure 28
Remove the
black reservoir
drain plug from
the bottom of
the reservoir.
Figure 29
Turn the ice machine back on by pressing and
holding the "ON/OFF" icon for 3 seconds. The
display will indicate "ICE" mode. Press and hold the
"MENU" icon until a flashing "CLEAN" is dis-
played. Press the "ON/OFF" icon until "CLEAN"
stops flashing. Your ice machine will now enter
the clean cycle.
The clean and rinse cycle will take about 49 min-
utes.
After the clean cycle is complete the ice machine
will return to the "OFF" position.
After the cleaning cycle is completed, verify that all build-up
has been removed. If not repeat the clean cycle procedure.
ICE
CLEAN
OFF
Refer to your cleaning solution instructions to determine
the proper amount of cleaning solution to add based on
2 quarts (1.9 liters) of water. Lift fascia door up to access
evaporator plate (See Figure 29). Pour the cleaning
solution slowly on the evaporator plate so it flows down into
the fresh water reservoir. (See Figure 30).
Figure 28b
Splash shield
brackets
Replace the splash shield if removed.
Pour cleaning solution slowly
onto the front edge of evaporator
plate behind the grid cutter.
Figure 30
Evaporator
plate
Grid cutter
Splash shield
Lift fascia door up to
access evaporator plate
