LX Zeus
February 5, 2013
- 41 -
3.5.4.1
Task Restart function
After task has been started (method doesn’t matter)
a task restart can be executed at any time.
Use
Restart
button of TSK menu.
Restart button
will become active after task start.
After restart all task statistics data will be zeroed and
ARM status will become active, which makes
possible to provide next automatic start.
3.5.4.2
Over Turn point
Change over to next turn point may be automatic
or manual. Automatic change over will happen
when
Auto next
of individual zone is set to auto.
Default setting for Auto next:
-R1below 10 km Auto next active (automatic change over)
-R1 above 10 km manual change over necessary
3.5.5 MOVE Function (during flight)
When flying an AAT big sectors are set and therefore
the pilot has to decide where to turn to next point.
Function Move helps the pilot to find optimal solution.
After long pres on TSK / MOVE button so called
move function will become active.
Use Zoom and Vol knobs to move the turn point.
All task relevant data which are affected by move
are shown at the bottom part of the display.
3.6 Flarm functions
Note!
Change over to next TP is the same as
described in 4.5.4. As turn point data is
taken actual position which is synchronized
with change over time.
Note!
Manual change over is possible exclusively
by
Next TP
command.
