LXE MX3, User Manual

Page: 19 / 64

Power Button 13
E-EQ-MX3RFIDOGWW-A MX3-RFID User’s Guide
Always replace the used main battery with a fully charged main battery. The Battery Low
Warning LED illuminates red at approximately 35% of power left in the main battery. You need to
determine the point at which battery life becomes unacceptable for your business practices and
replace the main battery before that point.
Note: Until the main battery and backup battery are completely depleted, the mobile device is
always drawing power from the batteries (On). After the backup battery and main battery
are depleted (dead), then when a fully charged main battery is installed, and the device
powered On again, the mobile device reverts to the last saved default (factory) values.
Follow the steps in “Getting Started”.
Power Button
Note: Refer to the section titled "Power Modes" in the “MX3-RFID Reference Guide” for
information relating to the power states of the mobile device.
Figure 15 Power Button
The power button is located above the ESC key on the keypad. When a battery is inserted in the
mobile device press the Power button.
Quickly tapping the Power button places the device immediately in Suspend mode. Quickly
tapping the Power button again, or tapping the screen with the stylus, immediately returns the
device from Suspend.
When the Windows desktop is displayed or an application begins, the power up (or reboot)
sequence is complete. Please refer to the section titled "Power Modes" in the
MX3-RFID
Reference Guide for a list of the kinds of activities (Primary Events) that will return the device
from Suspend Mode.
Restart Sequence
Tap Start | Run, type
warmboot
in the text box, then press the Enter button. If the touchscreen is
not accepting taps or needs recalibration, press <Ctrl>+<Esc> to force the Start Menu to appear.
When the Windows desktop is displayed or an application begins, the power on (or reboot)
sequence is complete. If any changes to the settings had been saved previously, they are restored
on reboot.
Any RFID tag data retrieved and not saved is lost during a reboot or reset.