LUXX LIGHTING LUX-200-277-90, User Manual

Page: 7 / 19

RJ14 Twist Lock Power
CONNECTING UP TO 200x 200W LED BARS
How to connect the 200w LED Bar to our NX-1 Controller:
• Slide the switch on the bottom of the 200w LED Bar to the EXT/OFF position in order to receive a signal from the NX-1 Controller.
• Plug the RJ14 connector coming out of the power cord into the single connector end of a RJ14 splitter.
• Plug the RJ9 end of a controller cable (included with the NX-1 Controller) into the RJ9 main port of the NX-1 Controller.
• If a two room setup is used or if more than 100x 200w LED Bars have to be connected, plug a second controller cable in the RJ9 aux port.
• Plug the RJ14 end of the controller cable(s) into the dual connector end of the RJ14 splitter.
• Plug either end of an interconnect cable into the other dual connector end of the RJ14 splitter.
• Plug the other end of the interconnect cable into the dual connector end of the following RJ14 splitter.
• Repeat this process to connect up to 100x 200w LED Bars on the RJ9 aux port.