Luxor SDE3.6, Instruction Manual

Page: 24 / 28

24 | ENGLISH
OPERATION
CHARGING THE BATTERY:
• Connect the power supply to a suitable mains
socket.
• Plug the charger plug into the charging socket on
the bottom of the handle of the tool.
• Charge time is approx.: 5-7 hours.
• When the battery is loaded, the red power light
keeps illumining until the charger is disconnected
from mains socket.
Note:
During charging the battery will become warm
as it is being charged. This tool has to be fully
charged before use.
LED WORK-LIGHT:
• The LED work-light will light when you press the
ON/OFF switch.
DRIVING AND REMOVING SCREWS:
• Your tool is equipped with a three-way switch
that allows you to change the chuck’s rotation
direction.
• The switch has 3 positions:
Driving- Stop- Removing.
1. Clockwise rotation, press the top.
2. Counter clockwise rotation, press the bottom.
3. To stop the rotation, release the switch.
Note:
The spindle is locked when the screwdriver
is switched off, this means that you can use the
screwdriver to insert and remove screws even if the
battery is discharged.
• Place the required screwdriver bit straight into the
collet chuck on the drive shaft or use a magnetic
holder as an extension.
Bit Magnetic holder