4 / 12
1
1
3
2
Adjust upper and lower poles
Locate the spring plungers inside the bottom grommet hole of pole
B1 (If your unit has B5 cross bar pre-installed remove prior) . Starting
with the right side pole B2, push the spring plunger down and pull
B2 up slightly and twist it slightly so that the spring plunger remains
offset. This will make adjusting the pole easier. (figure 1)
Repeat the same steps for the left side pole B2 but use your
right foot for stability instead . Align poles B2 and lock the spring
plunger into place. (figure 3)
Remove B5
before step 1 .
Only for FP2000, FP2500, FP2750
Hold the poles B1 & B2 with your hands and use your left foot on
the cross bridge of B1 for stability . Pull B2 upward until you reach
your desired height . Twist B2 so that the spring plunger locks into
the nearest spring plunger hole. (figure 2)
B1
B1
B1
B2
B5
B2
B2
B2
Spring
plunger
Spring
plunger
B3 is
pre-installed
figure 1
figure 2
figure 3
Lift pole assembly so that the part remains upright and the
cable management holes are facing toward you.
