6
To verify the compatibility of your system, follow two steps for
testing: 1) Connect the PP3 battery. ) Press
1
and
2
together for more than seconds. The Keypad will send the
Panic signal to the Control panel/Siren. If the Control panel/
Siren does not react, adjust the jumper link J3 accordingly.
6. Seat the PP3 battery into the battery compartment.
7. Replace the rear cover and refit fixing screws. Do not over-tighten
the fixing screws.
8. Refit the Keypad by slanting 45° onto the wall mounting plate.
Do not over-tighten the fixing screw. (Fig. 5).
Fig. 5
Note:
The Keypad is supplied with a default User Access Code
of: 134. For security reasons, it is recommended that this
code is changed to another four digit number which only you and
other users of the system know.
Note:
Use thumb and middle finger to hinge down the Keypad
cover. (Fig. 6) The Keypad has a back light illumination facility.
It will illuminate for 5 seconds when you open the Keypad cover
or press any key.
