11
code to factory default by following the steps below:
1. Remove the battery.
. Press and hold any key for more than 1
second.
3. Set the Jumper link J as shown on Fig.
7b.
4. Refit the battery and test it by pressing the default User Access
code of 1 3 4.
5. If the testing is ok, set the jumper link J as shown on Fig. 7a,
which is what the Keypad is set to normally.
Changing the User Access Code
Default Code: 1 3 4
When using the Keypad the keys must be pressed firmly and
within five seconds of each other. If you make a mistake, wait five
seconds and recommence programming from the beginning of the
sequence. To change the User Access Code, press the following
keys in sequence:
1. Press
1
.
. Enter the existing User Access Code
?
?
?
?
,
User Access Code
.
3. Press
1
; the
LED will illuminate once and flash twice.
4. Press your new User Access Code
?
?
?
?
,
User Access Code
.
1
J 2
1
J 2
Fig. 7a
Fig. 7b
