1
5. Press
1
; the
LED will illuminate once and flash three
times to confirm the setting has been accepted. If the LED
does not flash, wait five seconds and re-enter the programming
sequence from the beginning.
Disabling the Keypad
If a sequence of more than 16 incorrect key presses is entered
the Keypad will be disabled for 1 minute. If consecutively disabled
3 times, the Keypad will emit a Tamper signal to the control panel
with LED flashing slowly.
Note:
When the Keypad is disabled for 1 minute, the LED will
flash slowly, indicating that the Keypad is shut down temporarily.
During this 1 minute, any key presses will be treated as invalid
pressing. After the elapse of 1 minute, correct inputting will be
accepted.
Replacing the Batteries
The “LOW BATTERY” indicator on the front of the Keypad will not
flash until the Keypad emits a radio signal. Therefore the “LOW
BATTERY” indication won’t be seen in normal circumstance. The
batteries should be replaced as soon as possible as follows:
1. Press the User Access code twice, and the two LEDs ( &
) will keep flashing for 0 seconds. During this 0 seconds
duration, no radio signal will emit and any inputting will not be
accepted. In this way, the Keypad won’t emit radio signal when
replacing the battery.
. Undo the fixing screw at bottom of Keypad and remove from the
wall mounting plate.
