Lux Tools SWS 300 electronic, Original Operating Instructions

Page: 15 / 100

15
GB
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Installing the dust collector (Figure 2-3/Item 6)
The dust collector (6) must be connected to the
dust extractor connector (a).
The dust is extracted directly through the
grinding/sanding paper and the orbital disk and
into the dust collector.
To empty the duct collector, open it as shown in
Fig. 3 and carefully tap it to remove the debris.
5.2 Installing the dust extractor adapter
(Figure 4/Item 9)
Connect the dust extractor adapter (9) to the dust
extractor connector (a) as shown in Fig. 4 and
secure it by turning it. Connect the dust extractor
adapter to a suitable dust extraction system.
Important.
The use of the dust collector or a dust extraction
system is absolutely essential for safety reasons.
5.3 Securing sanding/grinding paper using a
Velcro fastening (Fig. 5)
Only use sanding/grinding paper of the
appropriate size and suitable perforations.
Place the sanding/grinding paper on the
oscillating plate (7) as shown in Fig. 5. Make
sure that the perforations in the sanding/grinding
paper line up with the oscillating plate.
5.4 Securing sanding/grinding paper using a
clamp (Fig. 6)
Only use sanding/grinding paper of the appropriate
size and suitable perforations.
Raise the lever (8) on the front of the orbital
sander slightly and detach it.
Insert the sanding/grinding paper as far as
possible into the open clamp and close the lever
again.
Place the sanding/grinding paper taut over the
orbital plate (7) and clamp it again using the
second lever (8) on the rear of the orbital sander.
Make sure that the perforations in the
sanding/grinding paper line up with the oscillating
plate.
6. Operation
6.1 Switching the machine on and off
(Fig. 7/Item 2)
To switch on:
Press the control switch (2).
Continuous operation:
Lock the control switch by pressing the locking
switch (4).
To switch off:
Press the control switch briefly and release it.
6.2 Speed control (Fig. 7/Item 3)
To pre-select the speed turn the knurled screw (3) on
the switch.
Plus direction: Higher speed
Minus direction: Lower speed
Anleitung_SWS_300_electronic_SPK7:_ 27.12.2010 13:23 Uhr Seite 15