Lux Tools 401 122, Original Instructions Manual

Page: 30 / 96

30
Cleaning and maintenance
Cleaning the device
Careful handling and regular cleaning ensure
that the device will remain functional and
powerful for a long time.
– Brush off coarse dirt.
– Wipe down the device with a slightly
damp cloth.
– Never spray the device with water or sub-
ject it to water.
– To clean, never use cleansers or solvents.
This can cause irreparable damage to the
device. The plastic parts can be eaten
away by the chemicals.
Maintenance
Changing the blades
►
P. 4, item 5
– Loosen the closure screw (4) and fold out
the hopper.
►
P. 4, item 6
– Insert a suitable object (Allen key etc.) as
shown and hold it in the hole (14).
– Loosen the screws (15) with the Allen
key.
– Turn or replace the blade (16).
– Install in the reverse order.
Storage and transport
Storage
• Allow the device and to cool off com-
pletely in storage.
• Store the device in a dry place.
Transport
• Secure the device against slipping.
• When shipping, use the original packag-
ing if possible.
Faults and remedial measures
When something isn’t working…
Often only small faults cause a malfunction.
You can usually easily remedy such faults
yourself. Please consult the following table
before contacting your local OBI store. This
saves effort and possibly also costs.
DANGER! Risk of injury!
Before all
cleaning and maintenance work,
switch the device off and disconnect
the mains plug. Wait until all moving
parts have come to a complete stop
and the device is cooled off.
Note:
Blades can also be sharpened.
However, this should be done by a
professional since both blades must
maintain the same weight in order to
maintain the proper balance. An
imbalance of the blades can cause
damage and injuries.
WARNING! Risk of injury!
Make
sure that unauthorized persons do
not have access to the device!
DANGER! Risk of injury!
Improper
repairs can cause your device to stop
functioning safely. You thus endan-
ger yourself and your environment.
Fault/malfunction Cause Remedial measure
Motor not running. No mains voltage? Check cable, plug, socket and
fuse.
Cable faulty? Contact your local OBI store.
Was the motor protection triggered? Remove all chipped pieces
and press reset button.
Was the safety switch not triggered? Check the connection hopper-
motor housing.
Locking lever in bottom position? Change locking lever to top
position.
Material to be chipped is
not pulled in.
Material blockage? Remove all chipped pieces
from the blades.
Are the blades blocked? Remove all chipped pieces
and press reset button.
GB
Haecksler_401122.book Seite 30 Donnerstag, 7. April 2016 8:40 08