Lux Tools 396970, Original Operating Instructions, Page: 14 / 38

14
GB
– Check that the cutting disc can run freely.
– Check there is sufficient cooling water in the pro-
duct.
Operating controls
On-/Off-Switch
Figure 16– Page 7
– Switching on:
The product can be switched on by pressing the
green I-Button on the On-/Off-Switch (7).
Wait until the cutting disc has reached its maxi-
mum speed before commencing work.
– Switching off:
The product can be switched off by pressing the
red 0-Button on the On-/Off-Switch (7).
Workpiece stops
Mounting the parallel stop
Figure 17– Page 7
– Open closure (8).
– Position the parallel stop (9) on the rail (26).
– Push down closure (8).
Adjusting parallel stop
– Open closure (8).
– Push the parallel stop (9) to the desired distance.
– Push down closure (8).
Mounting/setting the mitre stop
Figure 18– Page 7
– Place mitre stop (6) on parallel stop (9).
– Loosen tommy screw (27).
– Set mitre stop (6) at desired angle.
– Tighten tommy screw (27).
Setting product for jolly cuts
Figure 19– Page 7
– Raise the table insert (2) approx. 45°.
– Fold out the holder (28) and position in the
locator (29).
Notes on operation
– Adjust desired distance of the parallel stop from
the cutting disc ( Workpiece stops– Page 14 ).
– Setting the desired angle of the mitre stop
( Mounting/setting the mitre stop– Page 14 ).
– Setting the device for jolly cuts ( Setting product
for jolly cuts– Page 14 ).
– Switch on the product by pressing the green I-
Button on the On-/Off-Switch ( On-/Off-Switch–
Page 14 ).
– Position the workpiece against the parallel or
mitre stop or table insert.
– Push workpiece towards the back and cut
through in one operation.
– Switch off the product by pressing the red 0-
Button on the On-/Off-Switch ( On-/Off-Switch–
Page 14 ), if you will not be working with it again
immediately.
– Drain cooling water out of the product on com-
pletion of the work ( Replacing the cooling
water.– Page 15 ).
WARNING! Risk of injury! Always pull out
the mains plug in case of power failure
(disconnect the product from its power
supply). The product will start-up automa-
tically as soon as power is restored.
Note: The mitre stop can be set to a new
angle. The mitre stop can only be used
when the parallel stop is mounted
(
Mounting the parallel stop– Page 14 ).
WARNING! Risk of injury! Maintain an
adequate distance from the cutting disc
when cutting.
WARNING! Risk of injury! Do not reach
into the working range of the spinning cut-
ting disc while the product is operating.
CAREFUL! Product damage! Carefully
check the workpiece to be machined. For-
eign bodies such as nails, screws or simi-
lar can seriously damage the product.
CAREFUL! Product damage! The pro-
duct is not suitable for cutting materials
such as marble, fine stoneware and gra-
nite. Tile floor made up of these materials
must not be cut.
CAREFUL! Product damage! Wait until
the cutting disc has reached its maximum
speed before commencing work.
CAREFUL! Product damage! Before
commencing work, check there is suffici-
ent cooling water in the product.
Note: In the case of complex cuts (mitre
or jolly) we recommend making a test cut
beforehand.
396970_Fliesenschneider_klein.book Seite 14 Dienstag, 5. April 2016 12:06 12