Lux Tools 396970, Original Operating Instructions, Page: 16 / 38

GB
Mounting the cutting disc
– Installing cutting disc ( Fitting the cutting disc–
Page 12 ).
Storage and transport
Storage
Transport
– Dismantle any components that protrude from
the product.
– Use the original packaging to ship whenever
possible.
Disposal
Disposing of the product
Products marked with the symbol
shown opposite must not be disposed
of in the normal household waste. You
are obliged to dispose of such electri-
cal and electronic devices separately.
Please ask your local authorities for information on
the disposal options available.
Separate disposal ensures that the used products
are submitted for recycling or other forms of re-use.
It means you are helping to prevent harmful materials
being released into the environment.
Disposing of packaging
The packaging consists of cardboard and appropri-
ately marked films, which can be recycled.
– Take these materials to a recycling facility.
Troubleshooting
If something doesn't work…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the
purchase
store. You will save yourself a lot of
trouble and pos-sibly money too.
If you can't fix the fault yourself, please directly con-
tact your nearest
purchase
store. Please note that
impro-per repairs also void warranty claims and you
may
16
incur additional costs.
WARNING! Risk of injury! Store the pro-
duct so that it cannot be switched on by
unauthorized persons. Ensure that
nobody can injure themselves on the pro-
duct while it is stationary.
CAREFUL! Product damage! Do not
store the product unprotected in a humid
environment.
DANGER! Danger of death! Improper
repairs can result in the product functio-
ning unsafely. This endangers yourself
and your environment.
Fault/fault Cause Remedy
Motor not running. No mains voltage? Check cable, plug, socket and fu-
se.
Motor runs, cutting disc remains
still when subject to load. Flange nut loose? Check the flange is seated cor-
rectly and tighten if necessary.
Cutting disc runs irregularly/vibra-
tes. Cutting disc warped? Replacing the cutting disc–
Page 15
.
Cutting disc fitted incorrectly? Fit the cutting disc correctly
(
Mounting the cutting disc–
Page 16 ).
Cutting disc is discoloured. Insufficient cooling water? Filling the product with water–
Page 13
.
Lateral friction caused by cut ru-
nout? Guide workpiece through cutting
disc more slowly.
396970_Fliesenschneider_klein.book Seite 16 Dienstag, 5. April 2016 12:06 12