Lux Tools 396970, Original Operating Instructions, Page: 13 / 38

GB
13
Figure 9– Page 5
– Place cutting disc (4) on inner flange (20)
– Attach the outer flange (19)
– Screw hexagon nut (17) onto motor shaft (18)
clockwise
– Lock outer flange (19) to prevent turning using
hook wrench
– Attach the angled wrench to the hexagon
nut (17)
– Tighten hexagon nut (17) clockwise using angled
wrench
– Re-attach lower cutting disc cover (13) and tigh-
ten screw (16)
– Refit table insert (2)
Assemble/adjust splitting wedge
Figure 10– Page 5
– Raise the table insert (2) approx. 45° and
remove.
Figure 11– Page 5
– Loosen screw (16) and pull off cutting disc
cover (13).
Figure 12– Page 6
– Push splitting wedge (11) through gap (22) in the
housing from below.
– Attach the splitting wedge (11) to the screw (21).
– Gently tighten screw (21) with a suitable tool.
– Align splitting wedge (11) with the cutting
disc (4).
– Tighten screw (21) with a suitable tool.
– Refit table insert (2).
Mounting the upper cutting disc guard to the
splitting wedge
Figure 13– Page 6
– Push the upper cutting disc guard n (1) on to the
splitting wedge (11).
– Push screw (24) through upper cutting disc
protection (1) and splitting wedge (11).
– Push the washer (23) onto screw (24).
– Screw and tighten tommy nut (12) onto
screw (24).
Filling the product with water
Figure 14– Page 6
– Raise the table insert (2) approx. 45° and
remove.
Figure 15– Page 6
– Insert the plug r (25) into the drain opening.
– Fill the product with water only until water can
drain from the opening in the plug.
Attaching parallel stop
– Workpiece stops– Page 14 .
Operation
Check before starting!
Check the safe condition of the product before plug-
ging the power cable:
– Check whether there are any visible defects or
faults.
– Check whether all parts of the product are firmly
attached.
– Check that the safety devices are in faultless
condition.
WARNING! Risk of injury! The splitting
wedge must always be aligned parallel to
the cutting disc.
WARNING! Risk of injury! Do not over-
tighten screw and tommy nut. The upper
cutting disc guard must be able to move
freely.
CAREFUL! Product damage! Fill the pro-
duct with water only until water can drain
from the opening in the plug. During use
the water level must never drop below the
MIN marking.
CAREFUL! Product damage! Fill the pro-
duct only with clear water. Never use che-
micals or cleaning agents. This can cause
irreparable damage to the product.
CAREFUL! Product damage! Drain coo-
ling water out of the product on comple-
tion of the work (
Replacing the cooling
water.– Page 15 ).
WARNING! Risk of injury! The product
must be mounted in a stable position,
i.e. on a workbench, a universal subframe
or similar.
WARNING! Risk of injury! As soon as a
malfunction occurs, push the red 0-But-
ton on the On-/Off-Switch and pull out the
mains plug.
WARNING! Risk of injury! The defect
may be put into operation only if no
defects or errors are found. Ensure that
any defective parts are replaced before
the product is used again.
396970_Fliesenschneider_klein.book Seite 13 Dienstag, 5. April 2016 12:06 12