
Subject to alteration.
ATDC
GB
8 WWW.LUVATA.COM
ATDC
Subject to alteration.
Luftvärmare ATD(A,G)
BRUKSANVISNING
Coiltech
R1046802
9(14)
Rätt till ändringar förbehålls.
1. Bryt strömmen till motorn (1)
2. Demontera tak- och bottendel för bättre åtkom-
lighet. (2 3)
3. Lamellvärmeväxlaren rengörs bäst genom att blåsa med
tryckluft eller genom högtrycks-tvättning. För att kunna
rengöra mot luftriktningen i lamellvärmeväxlaren vinklas
luftriktarna 90° mot lamellytan.
4. Vid rengöring med vatten:
Skydda motorn mot fukt genom att täcka den med plast
eller genom att sätta en skiva framför fläkten. Spruta först
hela värmeväxlaren med miljövänligt lösningsmedel under
lågt tryck. Högtryckstvätta med vatten efter 10-12 minuter.
Det är viktigt att hålla munstycket vinkelrätt mot
lamellytan och ej närmare än 150 mm. (4, 5)
5. Lamellkroppen får inte innehålla några rester av
lösningsmedel efter tvätt eftersom rester kommer
att binda nytt damm. Lameller som deformeras
vid rengöringen kan riktas med hjälp av en lamell-
kam (QLAZ-20) som beställs från Coiltech.
6. Kontrollera att kondensatavloppet är rent.
Rengöring
Figur 7. Rengöring av värmeväxlare.
Figure 7. Cleaning the heat exchanger.
Cleaning
1. Switch off the mains supply to the motor (1)
2. Dismantle the top and bottom sections to improve
accessibility. (2, 3)
3. The best method to clean the fin heat exchanger is to
use compressed air or a high pressure washer. To clean
against the direction of air in the fin heat exchanger
angle the deflectors 90° to the surface of the fins.
4. When cleaning with water: Protect the motor from
moisture by covering with plastic or by positioning a
board in front of the fan. First spray the entire heat
exchanger with environmentally friendly solvent at a
low pressure. High pressure wash with water after
10-12 minutes. It is important to keep the nozzle
square to the fin surface and no closer than
150 mm. (4,5)
5. The fin structure must not contain any remnants of
solvent after washing as this will help to bind new dust.
Fins deformed during cleaning can be straightened
with the help of a fin comb (QLAZ-20), which can be
ordered from Luvata Söderköping.
6. Check that the condensate drain is clean.
Maintenance and service