![background image](http://html1.mh-extra.com/html/lutron-electronics/seetouch-sg-2w/seetouch-sg-2w_manual_1951076007.webp)
7
Occupant Copy
Installation Instructions
For Reference ONLY
CAUTION!
This setting chart is FOR REFERENCE ONLY. DIP Switches 5-9 for Window Treatment
Wallstations are factory set and
SHOULD NOT
be changed. Correct operation of the wallstation is
not guaranteed if these dip switches are changed
.
5 6 7 8 9
5 6 7 8 9
SG - 3W
On
Off
SG - 3WRL
SG - 2W
SG - 3WD
SG - 5WRL
■
To add all window treatment zones on a Control Unit:
Press and hold the top
Scene button on the Control Unit to be controlled by the Wallstation for about 3 seconds
until the scene LEDs flash in unison. Repeat for each Control Unit that you want to add
to this Wallstation.
Note:
To remove a Control Unit from a Wallstation: Put the Wallstation in setup
mode, then press the OFF button (below scene buttons) of the Control Unit to be
removed until the scene LEDs stop flashing.
3.
Exit setup mode
. Press and hold the buttons indicated in Step 1 for about 3 seconds until the scene LEDs stop cycling .
2.
Identify the Control Unit(s) to be controlled by the Wallstation
(All Units must be addressed!)
■
To add an individual window treatment zone from a Control Unit:
Press the
ZONE
button for the window treatment zone to be controlled by the Wallstation. The
entire column of LEDs of this zone will turn on to indicate that the zone has been added.
Repeat for each window treatment zone to be added to this Wallstation.
Note:
To remove a window treatment zone from a Wallstation: Put the Wallstation in
setup mode, then Press the ZONE
button on the Control Unit. Once the
window treatment zone’s entire column of zone LEDs has turned OFF, the zone is no longer controlled by the
Wallstation.
LUTRON
Press here
to add
entire
Control
Unit
LEDs flash in unison
Off Button
Control Unit
All LEDs will light up
Press here to add an
individual window
treatment zone
FOR REFERENCE ONLY! DO NOT CHANGE DIP SWITCHES!
030747b 8/28/02 10:12 AM Page 7