®
Job Name:
Job Number:
Model Numbers:
Page
S P E C I F I C A T I O N S U B M I T T A L
Occupant Sensors
LOS-CDT Series
Sensors
Installation
Adjusting the “Lights Not On” Level
LOS-CDT-xxxxR only
Control Settings (Blue Knob)
LOS-CDT-xxxxR only
1. Place timer in Test Mode (see page 7).
2. Set photo cell to max.
Turn the blue knob full clockwise (lights on no
matter how bright the natural light is), then about
30 degrees counterclockwise.
3. Check for Lights-Out.
Move from underneath the sensor, and remain
still until the lights turn off. Move around normally
to turn the light on.
4. Adjust to desired level.
If lights remain off, adjust the blue knob another
30 degrees counterclockwise and repeat step 3
until the lights turn on.
Note:
Set blue knob to 100% to disable photo
cell functionality and leave secondary dry contact
closure output functionality intact.
0
1000
0
1000
0
1000
Minimum (low):
Lights will never come
on, even though room is
occupied.
Maximum (high):
Photo cell has no effect on
operation (factory setting).
Normal:
200 to 600 LUX is normal
range.
369653b 9 05.04.12
9
