Lutool LT62068, Instruction Manual

Page: 14 / 19

9.4.3 Attaching / replacing the sand paper (Fig. 8)
With fast hook/loop fixation
This sanding plate is an equipped with a hook and loop rubber backing pad.
Fig. 8
Position the sand paper and press on by
hand. Press on the sand paper by giving it a
short, firm push against the flat surface of
the sanding plate (8) and switch on the
power tool. This ensures good adhesion and
prevents premature wear.
If the tip (front corner) has worn, pull off the
sand paper, turn it through 120º and place it
on again, or replace the sand paper.
9.5 Adjusting the speed (Fig. 9)
Fig.9
Before beginning, adjust the speed control according to
the application.
For example, we recommend a higher speed for work
with the scraper. Conduct a test run in order to find a
suitable speed.
The speed controller (6) can be set at 6 positions. The “1”-
position indicates the lowest speed and the
“6”-position indicates the highest speed.
You can adjust different speeds by turning the controller
from the “1”to the “6” position.
The operator may have to vary the speed to optimize
cutting efficiency.
6
12