Lunos Comfort Control TAC, Operating Instructions Manual

Page: 38 / 56

38
Via this screen you can change the mode of triggering the fan connected to this outlet. In the line ‚Mode‘
you can choose between „Automatic Sensor“ , „Automatic Timing“ and „Manual“, and in the line „Sensor“
you can select between different variables (Humidity, CO
2
(if connected)) and can then set the ‚‘Control
Range‘ for these variables etc. in the following lines.
In this menu, please select in which way the ventilation systems connected are to be triggered.
Via „Automatic Sensor“ the fans are triggered fully automatically via the adjustable control ranges. The
lowest value specifies when the fan is to change to a higher level for the first time, while the higher value
specifies that the fan will achieve the maximum volume flow rate available at this sensor value. Linear
control is applied between the respective values.
If control is made via Humidity
and CO
2
, control is made in accordance with the level with the higher
ventilation requirement.
You should only change the preset values if you are sure you must change these values!
3.3. Mode Outlet 1