Lunos Comfort Control TAC, Operating Instructions Manual

Page: 16 / 56

16
Proceed as described for navigation in the chapter ‚Control Keys‘, the type of navigation is always the
same:
Via the key „Λ“ you move from the start screen to the menu ‚Settings‘. If you want to change one of the
settings, press the key ‚OK‘ and then you can select the respective setting via the key „ Λ“ and „V“ and
move to the respective screen via ‚OK‘. Via „

“ you move back to the super-ordinate menu ‚Settings‘.
If you have a so-called configuration code as user or installer of the TAC (three blocks respectively with
five numbers and/or letters) and if this has been entered into the TAC, the control has already been confi-
gured and is operable. Manual settings are normally not required, but can be executed at any time.
Only use manual settings if the ventilation systems connected do not function as required or if you wish to
change e.g. thresholds of the sensor control.
The settings made in the configuration code are normally sufficient and are ideal settings for your indivi-
dual needs.
If you are not satisfied with manually actuated settings and are not able to restore the required functions,
you can reset to factory settings, i.e. to the settings of the original configuration code at any time via
‚Settings‘, or use the mechanical ‚reset‘ button on the bottom side of the TAC.
If you use the ‚reset‘ button, your previously stored manual changes remain unaffected (except for the
rapid access functions).
2. Settings