Luna 21149-0107, Manual

Page: 53 / 168

52
ENGLISH
Original instructions
CONTENTS
Introduction .............................................................. 52
Main parameters ....................................................... 52
Section 1: safety ....................................................... 53
Section 2: power supply ........................................... 54
Availability .............................................................. 54
Circuit requirements ................................................. 54
Grounding & plug requirements .............................. 54
Extension cords ........................................................ 55
Section 3:setup ......................................................... 55
Unpacking ................................................................ 55
Inventory .................................................................. 55
Clean up ................................................................... 56
Installation dimensions ............................................ 56
Check gearbox oil .................................................... 56
Test run lathe ............................................................ 56
Section 4: operate ..................................................... 57
General ..................................................................... 57
Controls .................................................................... 57
Removing/installing chuck or faceplate .................. 57
Dead centers ............................................................. 59
Tailstock positioning ................................................ 59
Changing tool posts.................................................. 59
Cross slide ................................................................ 60
Compound slide ....................................................... 60
Carriage handwheel ................................................. 61
Half nut lever ........................................................... 61
Carriage/cross feed lever .......................................... 61
Carriage lock ............................................................ 62
Gearbox levers ......................................................... 62
Threads and change gears ........................................ 63
Left threads and reverse cutting feed ....................... 63
Clutch overload ........................................................ 64
Section 5: maintenance ............................................ 64
Lubrication ............................................................... 64
Gibs .......................................................................... 66
Wiring diagram ..................................................... 147
Parts list .................................................................. 157
IDENTIFICATION
The following is a list of controls and components on
the lathe. Please take time to become familiar with
each term and its location. These terms will be used
throughout the manual and knowing them is essential
to understanding the instructions and terminology
used in this manual.
1. Thread Pitch Gearing & Speed Charts
2. Emergency Stop Switch
3. Speed Regulation
4. Lather or Drill Change Switch
5. Lathe Start
6. Lathe Stop
7. Gear Box
8. Clutch Overload
9. Lathe Chuck
10. Stopping Plate
11. Carriage Hand wheel
12. Cross Slide Hand wheel
13. Half Nut Lever
14. Carriage/Cross Feed Lever
15. Tailstock Barrel Hand wheel
16. Tailstock Clamp Bolt
17. Tailstock Center Lock
18. Compound Slide Hand wheel
19. Cross Slide
20. Tool Post
21. Carriage
22. Headstock Eye shield
23. Speed Displaying
24. Lathe Forward/Reverse Button
Model SC8 Main Parameters
Product Dimensions:
Weight ............................................................... 205 kg
Width (side-to-side) x Depth (front-to-back) x Height
......................................................... 140 x 53 x 44 cm
Footprint (Length x Width) ................. 140 x 15,5 cm.
Shipping Dimensions:
Type ..........................................................Wood Crate
Content ........................................................... Machine
Weight .............................................................. 245 kg.
Length x Width x Height ................. 156 x 68 x 61 cm
Electrical:
Minimum Circuit Size 10 amp (230 V) 20 amp (110 V)
Switch ...............................................Forward/Reverse
Motors: Main
Type ....................................................... W122-1500C
Output power .............................................. …1500 W
Amps ...................... 7,5 amp (230 V), 15 amp (110 V)
Speed .....................................................200–3500 rpm
Speeds ............................................................ Variable
Power Transfer ............................... Belt Drive to Gear
Bearings ...........Shielded and Permanently Lubricated
Main Specifications: