Lumber Jack DP13-580B, Safety And Operating Manual

Page: 10 / 22

DP13-580B 08
ASSEMBLY INSTRUCTIONS
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note: Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Base and column assembly
1. Position the base on the floor. Remove the
protective covering and discard.
2. Remove protective sleeve from the column
and discard. Place the column assembly on the
base, align the holes in the column support with
the holes in the base.
3. Locate three long bolts from the parts bag.
4. Install a bolt in each hole through the column
support and the base and tighten with the
adjustable wrench.
Installation of the table /support assembly
and hardware
1. Locate the table/support assembly.
2. Slide the table/support assembly onto the
column.
3. Locate the support lock handle among the loose
parts.
4. Install the support lock handle from the left side
into the table support. Raise the table to working
height by sliding it on the column and then by
tightening the lock handle by hand.
Installation the head
1. Remove the protective covering from the head
assembly.
2. Carefully lift the head above the column and
slide it down on the column as far as it will go.
Align the head with the table and the base.
3. Using a 4mm hex. Key, tighten the head set
screws on the right side of the head.