Find a suitable place for the temperature sensor and the controller. Hang the
sensor between the plants at average canopy height and preferably not
against the wall. Do not position in direct airflow or light. If you are using another
climate control system, hang temp sensor close to the sensor of that system.
Position and affix controller to the wall using mounting screws
(E)
through the
mounting loops.
Connect the power input
(B)
and the temperature probes
(E)
. The display will
light up and you can continue to set up the controller.
Connect controller cable
(C/D)
from Zone A/B output port (3) to ‘Signal In’
port on LED fixture 1 or ballast 1 IN port.
Warning!
The controller may only be connected to compatible Lumatek controllable
LED fixtures and ballasts.
6.
7.
8.
9.
ZONE B LIGHT
SIGNAL OUTPUT
ZONE A LIGHT
SIGNAL OUTPUT
ZONE B THERMO
SENSOR OUTPUT
ZONE A THERMO
SENSOR OUTPUT
POWER ADAPTOR
SOCKET
Note!
Whilst keying in settings if no operation is performed within 10 seconds
the display will revert to Home screen.
5.2
Setting up the controller
1.
Function keys
RIGHT SHIFT
INCREASE OR
DECREASE
PARAMETERS
OK AND SAVE
SET BUTTON
TOGGLE 0-10V LED
& RS485 HID CONTROL
PAGE UP OR
PAGE DOWN
