Note!
Each of the controller’s two channels (Zone A & Zone B) can control up to
200 Lumatek Control fixtures or ballasts. It is possible to use those channels to
control fixtures in two separate rooms or to control up to 400 fixtures in one room.
4. SAFETY GUIDELINES
5. INSTALLING THE CONTROLLER & FUNCTIONS
5.1
Preparations
For HID:
Warning!
Keep the controller away from fire, excessive heat, water, dust and
contamination.
Warning!
The Lumatek Digital Control Panel may only be used to control
compatible Lumatek controllable fixtures and ballasts. Do not connect the
controller to other products as this may be dangerous and may cause
malfunctions in the connected equipment. Doing so will void the warranty.
Warning!
Do not open or disassemble the controller, it contains no serviceable
parts. Opening the controller will void the warranty.
Warning!
Make sure the signal cables do not touch the reflectors as the
reflectors get very hot!
1.
Mount the fixtures or ballasts as per your lighting plan.
Interconnect them as described in the manual for the fixture or ballast
using the control cable (TRS) supplied with each controllable fixture or ballast.
Connect ballast 1 control cable from Out socket of ballast 1
to the In socket of ballast 2.
Connect ballast 2 control cable from Out socket of ballast 2
to In socket of ballast 3.
4.
3.
2.
Connect all remaining ballasts in series accordingly.
5.
Connect the ballasts or fixtures to the mains.
