LulzBot TAZ 3.0, User Manual

Page: 54 / 162

Your First 3D Print
Figure 4.4: Extruder filament slot
correct nozzle height. The nozzle should not be pushing down on the print
surface. To lower or raise the Z home height adjust the Z end stop trigger.
The red end stop trigger is on the far left of the printer mounted on the
X-axis motor mount. (Fig. 4.6, page 55). The red end stop trigger can be
lowered by turning clockwise and raised by turning counter-clockwise. Once
you have homed the axes and the hot end and bed have reached the correct
temperature it is time to print!
4.5 Z Print Height
Load the
bed level.gcode
file. This file can be found in the calibration
directory on the SD card included with your TAZ 3D printer or at:
http://www.LulzBot.com/support/downloads
. Place your mouse cursor
over the entry
Bed Level Check
, right click and select
Save as
Once you
have downloaded the file to your computer, press the
Load file
button
in Pronterface. Navigate through the file browser to the downloaded
bed level.gcode
file, highlight the file and select the
Open
button.
54