IRS31Pro-UMB
Operating Manual V10 / 01.2020
G. Lufft Mess- und Regeltechnik GmbH
42
15 Certifications
Certifications for the IRS31-Pro are listed below.
15.1 CE
The IRS31-PRO Sensor is in conformity with all relevant requirements of the RED Directive (2014/53/EU)
and RoHS (2011/65/EU). This device is compliant with the following standards:
Safety: EN 62368
EMC: EN 301 489
SRD: EN 300 440
RoHS: EN 50581
A formal DoC is available from
www.lufft.com
15.2 FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesirable
operation.
Any changes or modifications not expressly approved by the responsible party for compliance (G. Lufft
Mess- und Regeltechnik GmbH) could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
This device complies with FCC radiation exposure limits set for an uncontrolled environment.
This transmitter meets mobile/fixed limits as demonstrated in the RF Exposure Analysis (Section 2.5.2).
Labeling
The FCC identifier (FCC ID:
UF9-IRS31PRO
) is to be found on outer serial number sticker.
15.3 IC
IC (English)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
RF Exposure Statement
This device complies with the ISED radiation exposure limits set for an uncontrolled environment as it
meets the 2.5.2 Exemption Limits for Routine Evaluation – RF Exposure Evaluation for mobile/fixed as
defined in RSS-102
Labeling
The IC certification number (IC:
6650A-IRS31PRO
) is to be found on outer serial number sticker.
IC (français)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage ;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
