EN
18 |LUCTRA
English
DANGER!
Risk of fatal injury caused by drilling through supply lines!
Check for supply lines (e.g. power cables, gas and water pipes) before drilling into
the wall.
2. Drill the holes with ø 6 mm and 60 mm deep.
3. Fasten the clamp (5) to the wall with the enclosed ø 4.5 × 50 mm screws and rawlplugs.
4. Place the lamp onto the pin of the clamp (5).
Table-top mounting
1. Attach the adhesive foam pads (6) as shown.
2. Choose the orientation of the lower plate (7) depending on the thickness of the table and
tighten the clamping screw (9).
Note:
You can screw the clamping screws into three different holes. This allows you to over-
come obstacles, such as edge trims.
3. Fasten the lower plate (7) with the screws (8).
4. Fasten the clamp (5) to the table using the clamping screw (9). Tighten the clamping
screw (9) with the enclosed Allen key.
5. Place the lamp onto the pin of the clamp (5).
6. Run the power cable through the designated opening (10).
TABLE PIN
You have following mounting options available for the table pin (11):
Mounting with a cable hole
The table pin holds your lamp firmly on any mounting hole ranging from 20 mm to 80 mm.
1. Attach the adhesive foam pad (13) to the upper plate (12).
2. Place the upper plate (12) with the pin and threaded rod (16) from above into the mounting
hole.
3. Screw the lower plate (14) facing upwards onto the threaded rod (16) using a centring
gauge matching the diameter of the mounting hole.
4. Run the power cable through the designated opening (15)
WARNING!
Risk of damage to the cable!
Do not fasten the table pin by rotating the lower plate once you have run the power
cable through the designated opening (15).
Otherwise the cable will wrap around the threaded rod and be damaged.
5. Fasten the table pin by rotating the threaded rod (16). Use the enclosed Allen key to do this.
6. Place the lamp onto the pin of the table pin (11).
Mounting without a cable hole
You can fasten your lamp with the help of the table pin even if the table does not have a table
feed-through.
Summary of Contents for 9201
