Page
35
2. Make sure power is off during assembly.
3. Insert the RMAMs through the bottom of the motherboard and attach them to
the retention mechanism.
4. Fasten up the screws on the retention mechanism to tighten up retenion
mechanism and rmam. Check if all the piece parts are fastened tightly.
5. Put the CPU in the RM kit. (you must push the CPU horizontally into the RM
kit.)
Due to different packages of Celeron™, Klamath™ and Deschutes, there are 2 positions
to lock them in the RM kit. Below is notice to unlock those CPUs.
***Klamath™ & Deschutes : push the switch on
the CPU, and CPU will be loosen from the lock of
RM kit.
***Celeron™: use screw driver or anything alike to
draw this, and then pull one side of the CPU out.
CPU will be loosen this way.
Lock for
Klamath™ &
Deschutes
Lock for
Celeron™