Start-up procedure:
1
Remove the foil from the foam rubber feet and stick
these under the lower bowl.
2
At the intended location, fill the upper bowl with
water up to approx. 2 cm (3/4 inch) below the edge.
3
Now turn the upper bowl over and connect the flexible
tube with the inner connecting piece of the upper
bowl, if it is not already pre-installed (Figure 1).
(Moistening the tube makes insertion easier.)
4
Pull off the elbow fitting from the pump and connect
it to the other end of the tube.
5
Place the pump approximately in the middle of the
filled lower bowl and press it down firmly (Figure 2).
6
With one hand, take the upper bowl with the tube
that is now hanging down, and with the other hand,
stick the elbow fitting at the end of the tube back
into the opening of the pump. The elbow fitting will
point towards the back in the direction of the cord.
7
Guide the pump cord along the notches provided on
the upper and lower bowls (Figure 3).
8
Now set the upper bowl carefully on the lower bowl
and press it down as far as the silicon ring (Figure 4).
9
Plug in the power cord, and you’re done!
Before using,
check that all parts are on hand:
Lucky-Kitty
®
Cat Drinking Fountain
We are delighted that you have chosen the Lucky-Kitty
®
Cat Drinking Fountain. Please read through the following
instructions carefully and pay special attention to the
safety instructions. With proper use, you and your cat will
very much enjoy the Lucky-Kitty
®
Cat Drinking Fountain
for a long time.
Figure 1
Figure 2
Figure 3
Quality pump
incl. 12 V power adaptor
(with elbow fitting)
Start-up procedure:
Upper bowl
Lower bowl with
silicon ring
(pre-installed)
Foam rubber feet
Flexible tube
