Feel good with heat from electricity - www.technotherm.de
Installa� on and opera� ng instruc� ons for storage hea� ng
Feel good with heat from electricity - www.technotherm.de
GB
14|
System Start-up
Note: The heaters are fed from three circuits: (1) the element feed, (2) the charge con-
trol and (3) the discharge control circuit. All breakers must be off for the heater to be
safely de-energized to permit safe servicing.
Steps to ac� vate the system
1. Control Panel
- Energize control panel at the circuit breaker.
2. Fans and Thermostats
- Check proper opera� on of fans and thermostats. Check to
see that the fans go ON and OFF with opera� on of the thermostat.
3. Circuit Breakers
- Switch „ON“ all element feed circuit breakers.
4. Time Synchroniza� on
- Check the synchroniza� on of the control panel or � me clock
to have it coincide with the � me of day meter (see specifi c control panel instruc� ons
for further informa� on).
5. First Charge
- The heater insula� on is free from organic binding material. It can thus
be operated immediately without having to go on full charge in order to purge any
odours. It is, however, advisable, to ven� late the room well during the ini� al charging
phase.
6. Current Draw
- It is wise to check the current draw of each heater. See the Technical
Data Sheet for the proper amperage. This can be done at the breaker panel or at the
individual heaters.
Room Thermostat
The room thermostat must be installed according to na� onal and local codes of prac� ce.
It must also be earthed.
It is very important that the room thermostat be correctly posi� oned on the wall.
• Air must be able to circulate freely around the thermostat.
•
The thermostat must be protected from direct sunshine and/or draughts.
•
Fix the thermostat to an inside wall opposite the heater itself (the ideal posi� on is
next to the door).
