Additional Installation Instructions
Removing the Cover Plate
WavePOINT-II - Quick Installation Guide
C-7
Removing the Cover Plate
C
Removing the cover plate of the WavePOINT-II unit may be
required in one of the following situations:
■
You would like to change or replace the network interface(s) of
your WavePOINT-II access point, or
■
You would like to access the ‘Reboot’ and/or ‘Forced Reload’
buttons on the WavePOINT-II Processor Module.
To remove the WavePOINT-II cover plate, proceed as follows:
1.
To remove the cover of WavePOINT-II, place your hands on
the cover as pictured Figure C-6 on page C-7.
2.
Gently pull the top of the cover towards you to release the
latches (located inside the cover).
Figure C-6 Removing the WavePOINT-II Cover Plate
3.
Lower the cover to remove it from the processor module.
1
2
wp2_c.book Page 7 Thursday, September 23, 1999 6:24 PM
