WavePOINT-II - Quick Installation Guide
B-1
B
WavePOINT-II Start-up
Configuration
Identify the Start-up Settings
2
Your WavePOINT-II access point comes with the WavePOINT-II
operating software factory installed. Together with this software,
the WavePOINT-II has also been loaded with a factory set
configuration, that allows for ‘out-of-the box’ operation.
NOTE:
The factory set configuration should not be confused with
a ‘default’ configuration. For example when performing a
‘Reboot’ or ‘Forced Reload’ (described in the
WaveMANAGER User’s Guide provided on the CD-ROM),
the unit will NOT return to the ‘factory-set’ configuration.
To connect to a WavePOINT-II, the WaveLAN parameters of each
wireless station should be configured to match the values as
identified for the WavePOINT-II unit.
■
When powering up WavePOINT-II for the very first time, these
values should match the values listed in Table B-1.
■
For normal operation these values should match the ones you
identified when configuring the WavePOINT-II unit. You are
advised to record this information this information on the
WavePOINT-II Configuration Record in this appendix.
■
When you set the WavePOINT-II device to ‘forced reload
mode’ these values should match the settings listed in the
WaveMANAGER IEEE User’s Guide.
wp2_c.book Page 1 Thursday, September 23, 1999 6:24 PM
