Table Installation
3. Installing the Telephone
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998)
14
Connecting the
Telephone Line
Cord
Follow these steps to connect the telephone line cord.
1
Plug one end of the telephone line cord into the jack
labeled LINE on the back of the base.
Note:
The Business Cordless 905 telephone comes with
two telephone line cords–one for PARTNER
Communications Systems and one for MERLIN
Communications Systems. The PARTNER cord is not
labeled. The MERLIN cord contains an orange label that
states, "Use this cord only if you are connecting to a
MERLIN Communications System." Be sure to use the
correct telephone line cord for your system.
2
Plug the other end of the telephone line cord into the
system’s station port as shown in the following illustration.
Plug Line Cord into System’s Station Port
Note:
This illustration shows the telephone line cord
plugged in locally at a PARTNER switch. Depending on
where your system switch is installed, however, you may
have to run additional wire in order to reach the switch.
3
Press the line cord into one of the two u-shaped
strain-relief grooves on the bottom of the base.
