34
Lucent Technologies Inc.
Manual
August 2000
Venus AT Command Reference Manual
S-Registers
(continued)
S-Register Definitions
Note: The current setting of each S-register may be displayed by the ATS<n>? command, where <n> is the S-reg-
ister whose setting is to be displayed.
S0—Auto-Answer Ring Number
This register determines the number of rings the modem will count before automatically answering a call. The user
can disable auto-answer by entering zero. When auto-answer is disabled, the modem can answer only with the A
command.
■
Range: 0—255
■
Default: 0
■
Units: rings
S1—Ring Counter
S1 is incremented each time the modem detects a ring signal on the telephone line. S1 is cleared if no rings occur
over a six second interval. This register is read-only.
■
Range: 0—255
■
Default: 0
■
Units: rings
S2—Escape Character (User-Defined)
S2 holds the decimal value of the ASCII character used as the escape character. The default value corresponds to
an ASCII +. The escape sequence allows the modem to exit data mode and enter command mode when on-line. A
value over 127 disables the escape process, i.e., no escape character will be recognized.
■
Range: 0—255
■
Default: 43 (+)
■
Units: ASCII
S3—Command Line Termination Character (User-Defined)
S3 sets the character used to terminate command line and result codes.
Note: This register value is not stored with the &W command.
■
Range: 0—127
■
Default: 13 (carriage return)
■
Units: ASCII