Airfusion Akmani Installation Instructions
53 |
P a g e
Setting DC Ceiling fan 2:
Turn off both ceiling fans 1 and 2 via the mains supply to the receiver.
Slide the cover of the battery compartment of the transmitter to access the DIP switches. This will be transmitter
2.
Change the position of the DIP switches in the remote transmitter 2, so that it will be different to transmitter 1.
Fig. 11
Install the 12VDC battery in the compartment. Please make sure the polarity of the battery is correct.
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own isolation
switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the “
” button on
transmitter 2
for 5 seconds within 30 seconds of switching the power to the
receiver of ceiling fan 2.
Once the transmitter is paired with the receiver of ceiling fan 1, it will make a beep sound twice. Turn ON/OFF or
change the speed of ceiling fan 1 by the transmitter to check the operation.
Note: The pairing of Transmitter and Receiver is not required if only one ceiling fan is installed. When more than
two ceiling fans are installed near each other, please refer to the instruction above.
Remote Control Buttons
: FAN ON/OFF BUTTON: Press the button to turn the fan on/off.
: SPEED INCREASE BUTTON: Press the button to increase the fan speed. The LED
indicator will indicate the fan speed (1-6 speed) accordingly.
: SPEED DECREASE BUTTON: Press the button to decrease the fan speed. The LED
indicator will indicate the fan speed (1-6 speed) accordingly.
: REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running
function. The fan must be operating to activate the reverse function.
Fig. 11
Fig. 12
