Quick Start Guide of Network Video Recorder
13
2.3
RS-485 and Controller Connection
Typical Connection :
Figure 2. 5
Controller Connection A
To connect PTZ to the NVR:
1.
Disconnect
pluggable block
from the RS-485 terminal block.
2.
Press and hold the orange part of the
pluggable block
; insert signal cables into slots and release the orange
part. Ensure signal cables are in tight.
3.
Connect A+ on PTZ to D+ on terminal block and B- on controller to D- on terminal block. Fasten stop screws.
4.
Connect
pluggable block
back into terminal block.
Make sure both the controller and NVR are grounded.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
