———————————————————
Zubehör von
—
Das Original
——
Rev. 01 31/03/2021
Seite 6 von 9
Mount right reservoir at the brake cylinder’s thread M6, as shown.
Instructions for rerouting cables hoses and wiring harnesses:
Throttle cable:
Route as original and check throttle cable for free movement on every steering
angle.
Brake hoses:
Mount attached brake hose with new seal rings.
Mind the mounting instructions
that are delivered with the brake hoses.
Connect 60° fittings to the master brake cylinder and
fix hoses at the right slider-tube with attached cable tie. Use attached rubberized clamps and
original bolts at the bottom yoke to guide the hoses.
Clutch cable:
Route as original.
Wiring harness:
The right cable needs to be pulled about 10mm out of the steering head cover.
Make sure that no cable, hose or harness is bended and stays tension-free over the whole
steering angle.
The conversion kit is now completely mounted. Always check local laws and your manufacturer’s
warranty conditions for using aftermarket parts on your bike!
Ride safe and have fun!
