Step 4 – Finishing Touches
To complete the installa�on, verify that all moun�ng, connec�on, and aiming work is finished.
● Verify all electrical connec�ons are �ght and secured. The installer is responsible for the integrity of all connec�ons.
● Verify all bolts and screws are �ghtened and properly torqued.
● Straighten up all cabling. Tie down all cables neatly. For all outdoor projects, use UV rated tye wraps and wire
management.
Care and Maintenance
All luminaires are prepared with a powder-coated finish. The finish on exterior luminaires may weather over �me,
depending on the environmental condi�ons at the installa�on site. Proper care of the luminaires will maintain their
performance and appearance.
Follow a regular maintenance schedule to retain op�mal light output and thermal performance. Remove any dirt,
leaves and other foreign debris from the luminaire housing. Wipe the op�cal lenses with a clean, dry, co�on cloth to
remove dust and other contaminants. A non-abrasive polycarbonate cleanser may be used periodically.
Troubleshoo�ng
Symptom
No light output
Power is off.
Bad wire connec�on.
Fuse blows or circuit
breaker trips
Control signal set to 0
Crossed wires or a supply wire is
grounding out.
Improperly sized fuse or breaker
Check if circuit power is on.
Check input wiring connec�ons.
Verify control signal
Check wiring connec�ons.
Improperly sized fuse or breaker
Possible Cause
Correc�ve Ac�on
Do NOT use any abrasives such as car wax, brass cleaners or other polishes or chemicals.
These may scratch, remove, or damage the protec�ve coa�ng, allowing moisture and
pollutants to come into contact with the aluminum, possibly discoloring or pi�ng the
finish.
WARNING
Before performing any work on the luminaire, shut off the power circuit, verify the
power is off with a mul�meter, and wait 2 minutes before handling luminaire to avoid
electrical shock. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO DEATH, SEVERE
INJURY, OR PROPERTY DAMAGE.
WARNING
Note:
When power is turned on, the luminaires default to 100% on unless a different control
signal is present.
Installation Instructions
Zone Sports Flood (ZNF)
Outdoor Sports Flood Light
