LSI Corporation
- 11 -
MegaRAID SAS 9285CV-8e RAID Controller Quick Installation Guide
March 2014
Attaching a CVFM03 Module to the RAID Controller and Connecting to a Remote CVPM02
Module
3.2.4
Attaching the CVPM02 Module to the Clip on the Remote Mount Board
Follow these steps to attach the CVPM02 module to the clip on the remote mount board.
1.
With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
2.
Remove the CVPM02 module from the package.
3.
Press the CVPM02 module into the clip on the remote mount board until the module clicks firmly into place, as
shown in the following figure.
Figure 7 Attaching the CVPM02 Module to the Clip on the Remote Mount Board
3.2.5
Connecting the CVFM03 Module on the RAID Controller to the CVPM02 Module on the Remote Mount Board
Follow these steps to connect the CVFM03 module on the MegaRAID SAS 9285CV-8e RAID controller by cable to the
CVPM02 module on the remote mount board.
1.
Place the controller on a flat, clean, static-free surface.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the cable included in the RAID controller box.
4.
Insert the smaller cable connector on the cable into the J2A1 cable connector on the CVFM03 module, as shown
in the following figure.
5.
Insert the larger cable connector on the cable into the cable connector that comes out of the remote
CVPM02 module.
Align the cable connectors to make sure they are connected correctly.
NOTE
You can insert the cable connector on the remote CVPM02 unit into
the larger 6-pin connector on the cable connector if the latch on one
cable connector aligns with the slot on the other cable connector. The
cable end inserts into the connector with minimal resistance.
3_01275a-00
Remote Mount
Board
CacheVault
Power Module
Clip
Summary of Contents for MegaRAID SAS 9285CV-8e
Page 16: ......
