Sphensor
–
User manual
LSI LASTEM SRL
INSTUM_04291
Pag. 18 / 32
➢
EnableData
: if checked, enable the sending to the MQTT broker of the sensors data (measu-
rements, diagnostics, etc.) in JSON format as well as binary.
5.
The
NETWORK
tab contains the specific parameters of the radio network.
The parameters have the same meanings as those set in sensors and repeaters. The communication
between all the apparatuses happens only if these parameters have been configured with the same
values.
6.
Press [SAVE] to save the configuration. The command causes a restart of Sphensor Gateway.
3.5
Verification of pre-installation operation
Before installing all Sphensor equipment, it is recommended to check its correct functioning. If the network
has been subdivided into sub-areas, it is advisable to proceed by sub-area.
➢
Place the Sphensor apparatuses on a table.
➢
Turn on Sphensor Gateway. Consider what is indicated at §
Errore. L'origine riferimento non è stata
trovata.
.
➢
Turn on, one by one, any sensors with repetition function verifying the ignition of the blue LED.
➢
Turn on, one by one, any repeaters available, verifying the lighting of the blue LED.
➢
Turn on, one by one, the sensors verifying that after a few moments the blue LED is switched on,
testifying that the sensor is properly connected to the network composed by Sphensor Gateway.
➢
Through the Sphensor Manager software, verify the reception of data from all sensors, taking into
account the scheduled transmission rate.
